Table of Contents
Advertisement
21
Removing the Module:
1.
Pull out the release handle to the open position.
2.
Pull the module out of the bay.
3.
Replace immediately with another module or with a dummy
module cover to maintain airflow integrity.
Configuring the CMM
To access/configure the CMM, you first have to configure the IP
settings of the CMM depending on you network environment. The
below procedure for this configuration just serves as a reference for
getting the CMM setup. If your system has Linux OS, please follow
similar instructions to get the CMM setup.
Requirements are:
•
Computer system with LAN (RJ45) port
•
RJ -45 Ethernet cable
The default IP of the CMM is 192.168.100.100. Configure the Computer
system (connected through Ethernet-LAN to the CMM) to the same
address range (for example 192.168.100.101).
Configuring the CMM in Windows OS:
Go to S
1.
TART
2.
Right-click on LAN to view properties.
C
P
ONTROL
ANEL
N
C
ETWORK
ONNECTIONS
Advertisement
Chapters
Table of Contents
