Table of Contents
Advertisement
545
Hit any key to stop autoboot: 5
3.
Once the boot sequence is interrupted, it will display menu
options.Use the "H" option to set hardware information by typing
the character H.
This will display the hardware information that can be changed.
4.
Configure the IP address for this switch (only for booting purposes)
using the command: ip=<IP address>
For example
5.
Configure the subnet mask for this switch IP address using the
below command:
mask=<subnet mask>
For example
6.
Configure the TFTP server IP address using the below command:
tftpaddr=<TFTP server IP>
For example
7.
Configure the gateway address to reach the TFTP server using the
below command if the TFTP server is in different network:
gateway=<gateway IP>
For example
8.
Configure the firmware image file name using the below
command:
ramdiskname=<filename>
For example
Save
9.
Type
to save the hardware information.
Exit
10. Type
to exit the hardware information menu.
11. Type F to download the firmware image. In this case it will
download to the normal image area.
12. On a successful download, the switch displays the below string.
Updating the ramdisk image ...
This may take awhile
OK
13. After a successful download, boot the switch to use this latest
firmware by typing J.
ip=192.168.2.3
mask=255.255.255.0
tftpaddr=192.168.2.100
gateway=192.168.2.100
ramdiskname= SBM-GEM-X2C-v5.2.10.bin
Advertisement
Chapters
Table of Contents
