Acer AB460 F1 User Manual page 352

332
Note:
Otherwise the slave switches will not allow you to configure
anything except
login name as "
Removing a stacked switch
To remove a switch from stacking follow the below recommended
procedure.
1. Disconnect stacking cables.
2. Reboot the removed switch as a standalone switch.
Disable
3. stacking.
4. Reboot the switch again to operate as regular stand-alone switch.
Note: When a switch is moved from stacking to stand-alone mode,
the saved stacking configurations can not be loaded in stand-
alone mode. When stacking is disabled, the switch software
renames the existing configuration file to avoid automatic
restoration of stacking configurations on a stand-alone switch.
Figure 4-212. Stacking Swtiches
In a stack only one switch can be configured as master.
stacking disabled
stackuser
" and password as "
4 Networking Switch Modules
. To login to slave switches, use a
stack123
".