Table of Contents
Advertisement
264
Note: After the module has been installed and the handle locked,
it will turn on and a POST test will run to verify it is working
properly. If there are no problems the blue
module will illuminate and you will see an
the G
E S
B
Note: If the module is installed in a top bay it must be positioned
upside-down.
Removing a Switch Module
1.
Pull out the release handle to the open position.
2.
Pull the module out of the bay.
3.
Replace immediately with another module or with a dummy
module cover to maintain airflow integrity.
screen of the management software utility.
WITCH
4 Networking Switch Modules
Init. OK
LED on the
OK
under I
NITIATED
in
Advertisement
Chapters
Table of Contents
