Table of Contents
Advertisement
Configuring the hot-swappable cage
This section includes instructions for removing and installing the
hot-swappable cage as well as procedures on how to install a hard disk
into the cage's hard disk carrier.
Note: The hot-swap SCSI HDD Cages can not be cascaded for
Altos G701 model.
Removing the hot-swappable cage
Important: Before detaching the hot-swappable cage from the
chassis, make sure to first remove all hard disks from their carriers.
For instructions, refer to the succeeding section.
1
Detach the chassis panels and remove the air baffle.
2
Loosen the four thumbscrews that secure the cage to the chassis
(1).
3
Slightly pull out the cage from the chassis (2).
4
Disconnect the following cables from the cage:
a
SCSI cable
37
Advertisement
Table of Contents
