Table of Contents
Advertisement
100
Figure 3-59. Installing a Hard Drive in a Carrier
Infiniband mezzanine card installation
All models of the Mezzanine HCA card are compatible with both blade
modules.
Card installation
1
Confirm that you have the correct card and three (3) screws.
2
Following the instructions, remove the blade module and open the
cover to access the mainboard.
3
In a standard, electro-magnetically protected workstation, secure
the card to the serverboard by gently but firmly attaching the card
to the two connectors.
4
Using a Phillips screw driver, secure and tighten each screw one at
a time. Do not overtighten the screws.
3 Server Blades: Setup and Installation
Advertisement
Chapters
Table of Contents
