Acer AB460 F1 User Manual page 83

63
Item Name
4 Default
Policy
5 Rule#
6 IP/Mask
7 Policy
8 Append
9 Insert
10 Replace
11 Delete
12 Max.
Number of
Failed
Logins
Description
When IP A C
CCESS ONTROL
either Accept or Drop from this pull-down menu to
either allow or deny access according to pre-defined
rules.
NOTE: If set to D and you do not have a set of rules that will
ROP
accept the Internet connection, then an Internet connection
over the LAN is impossible. In this case, you need to change
your security settings via modem or by disabling the IP A
C .
ONTROL
Enter a rule number in the box for a command (or
commands) that will be used by the IP A
Enter the IP address or an IP address range for which
the command(s) will be applied.
This item instructs the IPMI what to do with the
matching packages.
NOTE: The sequence or the order of the rules is important;
rules are checked in ascending order until one matches. All
rules below the matching one will be ignored. The default
policy applies if no matching rules are found.
Select this option to add IP Address/Mask, rules or
commands to the existing ones.
Select this option to insert IP Address/Mask, rules or
commands to the existing ones.
Select this option to replace an old IP Address/Mask,
rule or command with a new one.
Select this option to delete (a part of) an existing IP
Address/Mask, rule or command.
Enter the maximum number of failed attempts or
failed logins allowed for a user. If the number of failed
logins or attempts exceeds this maximum number
allowed, the user will be blocked from the system.
NOTE: If this box is left empty, the user is allowed to try to
login to the server indefinitely. For network security, this is not
recommended.
is enabled, you can select
CCESS
CCESS
C .
ONTROL