Acer AB460 F1 User Manual page 605

BIOS Message
PS/2 Mouse Boot Summary
Screen:
nnnn kB Extended RAM
Passed
nnnn Cache SRAM Passed
nnnn kB Shadow RAM
Passed
nnnn kB System RAM
Passed
One or more I2O Block
Storage Devices were
excluded from the Setup
Boot Menu
Operating system not
found
Parity Check 1 nnnn
Parity Check 2 nnnn
Press <F1> to resume,
<F2> to Setup, <F3> for
previous
Description
PS/2 Mouse installed.
nnnn
Where is the amount of RAM in kilobytes
successfully tested.
nnnn
Where is the amount of system cache in
kilobytes successfully tested.
nnnn
Where is the amount of shadow RAM in
kilobytes successfully tested.
nnnn
Where is the amount of system RAM in
kilobytes successfully tested.
There was not enough room in the IPL table to
display all installed I2O block-storage devices.
Operating system cannot be located on either
drive A: or drive C:. Enter Setup and see if fixed
disk and drive A: are properly identified.
Parity error found in the system bus. BIOS
attempts to locate the address and display it on
the screen. If it cannot locate the address, it
displays ????. Parity is a method for checking
errors in binary data. A parity error indicates
that some data has been corrupted.
Parity error found in the I/O bus. BIOS attempts
to locate the address and display it on the
screen. If it cannot locate the address, it displays
????.
Displayed after any recoverable error message.
Press <F1> to start the boot process or <F2> to
enter Setup and change the settings. Press <F3>
to display the previous screen (usually an
initialization error of an
add-on card). Write down and follow the
information shown on the screen.
Option ROM
, i.e., an
585