Acer AB460 F1 User Manual page 302

282
Parameter
Device Location
PIM Mode
Snoop forwarding
Mode
Switch Start MAC
address
Configuration
Restore Status
Device Up Time
HTTP Server Status
HTTP Port Number
This page also has a control to Reset To Factory Defaults. This clears all
switch configuration and local user accounts information. This reset
requires reboot of the switch.
Warning!
up before doing "Reset To Factory Defaults".
This page also provides a control to Reboot the switch. In stacking, the
Switch Identifier is displayed on top of this reboot button. You can
select the interested stack member switch to reboot the corresponding
switch. You can also select the ALL option to reboot all stack members.
Description
Use this parameter to change the device location.
Use this to configure the PIM status of the switch.
You can use this parameter to change the Snoop
Fowarding Mode between MAC based and IP based.
This is a display for the Switch Start MAC address.
This is a display for the Configuration Restore Status
This is a display for the Device Up Time.
This is a display for the HTTP Server Status.
This is a display for the HTTP Port Number.
Make sure to have all necessary configurations backed
4 Networking Switch Modules