Indication Description - Acer AB460 F1 User Manual

551
Feature
Internal/External
Ports
Bandwidth
The module includes an integrated Chassis Management Module
(CMM) installed as an add-on-module inside the switch chassis. This
allows installation of two (redundant) switches in the AB7000
enclosure without the loss of system management capability. Note that
a dual-port InfiniBand Add-On-Card is required if redundant switches
are installed.
Either the RJ45 connector or the KVM connector on the front of the
module can be used to connect to the integrated CMM module (see
Figure 4-225). There is also an activity indicator LED for the CMM on
the left-hand side of the front of the module.
The reset button (lower left), pushed once, will reset the module. If
held down for approximately 5 seconds it will send a signal to the
CMM, which cause the CMM to return to default settings.
See Chapter 4, Section 4.1 of the
information on the operation of the CMM itself, including instructions
on how to use both the KVM and RJ45 connections.
InfiniBand Switch LEDs
SBM-IBS-Q3616/M InfiniBand switch module LEDs are found below in
the following table.
LED
Module Status
LED
Description
Internal: 20 4X QDR copper ports/ External: 16 4X QDR
copper ports
4X QDR (40 Gbps) non-blocking architecture for 2.88
Tbps total bandwidth (36-port)
AB7000 User's Manual
State

Indication Description

Blink Switch is booting its firmware
Steady On Boot process failed
Off Switch is properly booted and operational
for more