Dvmrp - Acer AB460 F1 User Manual

469
Clicking the S
TATIC
which configure static PIM RPs (Rendezvous Points). The parameters for
this page are shown in the following table.
Parameter
Component ID
Address Type
Static Group
Address
Static Group Mask
Static RP Address

DVMRP

The DVMRP page allows you to configure the DVMRP protocol using
the following pages:
• "DVMRP Basic Settings" on page 470
• "Interfaces" on page 471
RP tab brings up the S
Description
This parameter specifies a number uniquely identifying
the component.
This parameter chooses the IPv4 or IPv6 address type.
This parameter represents the multicast group, for
which the switch advertises itself as the candidate RP.
This parameter specifies the subnet mask, which when
combined with the group address gives the group
prefix.
This parameter represents the IP address of the
candidate RP.
RP C
TATIC ONFIGURATION
page,