ADInstruments AD8000 Series Instruction Manual page 71

AD8000 Series Spectrum Analyzer Instruction
Manual
(2) Sweep Mode
There are two sweep modes; one is continuous (Cont) and the other is
single (Sigl). The default mode is continuous mode. If users wants to set the
sweep mode to single mode, users can set the 'Sweep' soft-key into 'Sigl' or
press the 'Single Sweep' sub-key to activate a single sweep; at the same
time a mark would show up at the upper right corner of the screen.
Single Sweep Mark
That image would sweep from left to right one time and then stop. Press
the key again to start another single sweep. Switch the soft-key to
continuous mode to change.
(3) Full-Automatic
Press the full-automatic soft-key to change all attributes including RBW,
VBW, attenuator, sweep time, frequency step and etc. into automatication.
Fig. 3-30 Single Sweep
57