Table of Contents
Advertisement
AD8000 Series Spectrum Analyzer Instruction
Manual
Annual Inspection & Calibration
1.3
All brenches and offices of AD INSTRUMENTS are responsible for the
annual
maintenance and calibration to ensure the proper use. It is
suggested that users do the maintenance and calibration regularly.
Protection of ESD
1.4
AD8000 series, like other high performance instruments, is susceptible to
electrostatic discharge (ESD) damage. Coaxial cables and antennas often
build up a static charge, which may damage the AD8000 input circuitry.
AD8000 operators must be aware of the potential for ESD damage and take
all necessary precautions.
It is recommended to discharge the static by connecting a short or load
device to the cable or antenna before connecting them to AD8000. It is
important to remember that the operator may also carry a static charge
that can cause damage. Following the practices outlined in the above
standards will ensure a safe environment for both personnel and equipment.
Battery Replacement
1.5
The battery can be replaced without the use of any tool. The battery
compartment is located on lower side of rear (when you are facing the
measurement display). Wring out two screws, slide the cover down and
remove the battery. Installation is the opposite of removal.
Note: Ensure the correct connection of battery joints and power lines,
otherwise connection would fail.
Fig. 1-1 Battery Replacement
3
Advertisement
Table of Contents
