Fm/Am - ADInstruments AD8000 Series Instruction Manual

AD8000 Series Spectrum Analyzer Instruction
Manual

FM/AM

3.7
Choose the FM/AM measurement in spectrum measurement, and enter
the interface.
Basic measurement:
1, press MEAS, choose field strength measurement type, and the device
would switch to field strength measurement mode.
2, make the current menu be the measurement setting, or press MEAS
SETUP to enter the measurement setting. The default is FM measurement,
which could be changed into AM measurement and the switch of audio
output.
3, press the FREQ key, and set the center frequency, frequency step and
the signal standard.
4, press the CPL key to set the track, sweep mode and sweep time.
5, press the MARK key to start to read the value of the marker.
6, press the PEAK key to set the peak value.
114
Fig. 3-104FM/AM Measurement