Send - Interlogix NS4702-24P-4X Command Manual

keep-ip Attempt to keep VLAN1 IP setup.
Default:
N/A
Usage Guide:
To store the device factory default settings.
Example:
To store the device factory default settings.
Switch# reload defaults

send

send
Command:
send { * | console 0 | vty <vty_list> } <message>
reload Reload system
* All tty lines
console Primary terminal line
vty Virtual terminal
Default:
N/A
Usage Guide:
To send message for command line user.
Example:
To send message ( hi, I will upgrade the firmware, OK? ) for command line user
(All).
Switch # send * 1
Enter TEXT message. End with the character '1'.
hi, I will upgrade the firmware, OK?
1
-----------------------------------------
*** Message from line 0:
hi, I will upgrade the firmware, OK?
-----------------------------------------
NS4702-24P-4X Managed Switch Command Guide
Chapter 4: Commands for CLI configuration
241