Interlogix NS4702-24P-4X Command Manual page 134

Chapter 4: Commands for CLI configuration
ntp-server NTP servers
<A.B.C.D> Server's IP address
Default:
None
Usage Guide:
To configure NTP Server of DHCP Server
Example:
To configure NTP Server (1.1.1.1) of DHCP Server for pool "IFSbestswitch"
Switch# configure terminal
Switch (config)# ip dhcp pool IFSbestswitch
Switch (config-dhcp-pool)# ntp-server 1.1.1.1
vendor
Command:
vendor class-identifier <"0x "> specific-info <HEX-VALUE>
vendor Vendor configuration
class-identifier
"<0x >" Class identifier in 64 characters
specific-info
<HEX-VALUE>
Default:
None
Usage Guide:
To configure Vendor ID and info of DHCP Server
Example:
To configure Vendor ID and info as below table of DHCP Server for pool
"IFSbestswitch"
Switch# configure terminal
Switch (config)# ip dhcp pool IFSbestswitch
Switch (config-dhcp-pool)# vendor class-identifier "0x8"
specific-info 0x8
ip dns proxy
Command:
ip dns proxy
ip Internet Protocol
dns Domain Name System
proxy DNS proxy service
Default:
Disabled
132
Vendor class identifier
Vendor specific information
Hex values in 64 octets
NS4702-24P-4X Managed Switch Command Guide