Interlogix NS4702-24P-4X Command Manual page 210

Chapter 4: Commands for CLI configuration
Usage Guide:
To enable the SNMP Service
Example:
To enable the SNMP Service
Switch# configure terminal
Switch (config)# snmp-server
snmp-server access
Command:
snmp-server access <group_name> model { v1 | v2c | v3 |
any } level { auth | noauth | priv } [ read <view_name> ] [ write
<write_name> ]
snmp-server
access access configuration
<GroupName : word32>
model security model
any any security model
v1 v1 security model
v2c v2c security model
v3 v3 security model
level security level
auth authNoPriv Security Level
noauth noAuthNoPriv Security Level
priv authPriv Security Level
read specify a read view for the group
<ViewName : word255>
write specify a write view for the group
<WriteName : word255>
Default:
None
Usage Guide:
To configure the Access of SNMP
Example:
To configure the Access (below table) of SNMP
Switch# configure terminal
Switch (config)# snmp-server access default_rw_group model
v2c level priv read default_view write default_view
snmp-server community
Command:
snmp-server community { v2c <comm> [ ro | rw ] | v3
<v3_comm> [ <v_ipv4_addr> <v_ipv4_netmask> ] }
208
Set SNMP server's configurations
group name
read view name
write view name
NS4702-24P-4X Managed Switch Command Guide