Interlogix NS4702-24P-4X Command Manual page 187

poe Power Over Ethernet
sequential PoE sequential is to delay power feeding when the switch is
enable poe sequential enable
Default:
Enabled
Usage Guide:
To enable Sequential Power up Option.
Example:
To enable Sequential Power up Option.
Switch# configure terminal
Switch (config)# poe sequential enable
poe sequential interval
Command:
poe sequential interval <1-30>
poe Power Over Ethernet
sequential
interval Set how long system should feeding power to next PoE interface <1-30>
<1-30> poe sequential enable
Default:
5
Usage Guide:
To configure Sequential Power up Interval.
Example:
To configure Sequential Power up Interval (30 seconds per port).
Switch# configure terminal
Switch (config)# poe sequential interval 30
poe sequential rule
Command:
poe sequential rule { port | priority }
poe Power Over Ethernet
sequential rule
port System sequential feeding power the PoE interfaces based port number.
priority Use priority command to configure sequential feeding power to PoE
interfaces based on port PoE priority.
Default:
Port
NS4702-24P-4X Managed Switch Command Guide
completely booted.
PoE sequential is to delay power feeding when the switch is
completely booted.
PoE sequential is to delay power feeding when the switch is
completely booted.
Chapter 4: Commands for CLI configuration
185