Interlogix NS4702-24P-4X Command Manual page 186

Chapter 4: Commands for CLI configuration
enable poe admin-mode enable
Default:
Enabled
Usage Guide:
To enable System PoE Admin Mode.
Example:
To enable System PoE Admin Mode.
Switch# configure terminal
Switch (config)# poe admin-mode enable
poe management mode
Command:
poe management mode { class-consumption | class-reserved-
power | allocation-consumption | allocation-reserved-power |
lldp-consumption | lldp-reserved-power }
poe Power Over Ethernet
management
mode mode
allocation-consumption
allocation-reserved-power
class-consumption
class-reserved-power
lldp-consumption
lldp-reserved-power
Default:
Allocation-consumption
Usage Guide:
To configure PoE Management Mode.
Example:
To configure PoE Management Mode as LLDP-consumption mode.
Switch# configure terminal
Switch (config)# poe management mode lldp-consumption
poe sequential enable
Command:
poe sequential enable
184
Use management mode to configure PoE power management
method.
Max. port power determined by allocated, and power
is managed according to power consumption.
Max. port power determined by alocated, and is
managed according to reserved power.
Max. port power determined by class, and power is
managed according to power consumption.
Max. port power determined by class, and power
managed according to reserved power.
Max. port power determined by LLDP Media protocol, and
power is managed according to consumption.
Max. port power determined by LLDP Media protocol, and
power is managed according to reserved power.
NS4702-24P-4X Managed Switch Command Guide