Interlogix NS4702-24P-4X Command Manual page 218

Chapter 4: Commands for CLI configuration
Switch# configure terminal
Switch (config)# spanning-tree aggregation
Switch (config-stp-aggr)#exit
Switch (config)#
no
Command:
no
no Negate a command or set its defaults
Default:
N/A
Usage Guide:
To default the function
Example:
To disable the function (spanning-tree auto-edge)
Switch# configure terminal
Switch (config)# snmp-server host IFS
Switch (config-snmps-host)# no spanning-tree auto-edge
spanning-tree auto-edge
Command:
spanning-tree auto-edge
spanning-tree
auto-edge Auto detect edge status
Default:
Enabled
Usage Guide:
To enable the Auto Edge of CIST Aggregated Port
Example:
To enable the Auto Edge of CIST Aggregated Port
Switch# configure terminal
Switch (config)# snmp-server host IFS
Switch (config-snmps-host)# spanning-tree auto-edge
spanning-tree bpdu-guard
Command:
spanning-tree bpdu-guard
spanning-tree
bpdu-guard
Default:
Disabled
216
Spanning Tree protocol
Spanning Tree protocol
Enable/disable BPDU guard
NS4702-24P-4X Managed Switch Command Guide