Interlogix NS4702-24P-4X Command Manual page 149

Switch# configure terminal
Switch (config)# ipv6 route 2001::7788/128 interface vlan 1
fe80::1
lacp system-priority
Command:
lacp system-priority <1-65535>
lacp LACP settings
system-priority
<1-65535> Priority value, lower means higher priority
Default:
32768
Usage Guide:
To configure LACP system-priority.
Example:
To configure LACP system-priority (99).
Switch# configure terminal
Switch (config)# lacp system-priority 99
line
Command:
line { <0~16> | console 0 | vty <0~15> }
line Configure a terminal line
<0~16> List of line numbers
console Console terminal line
vty Virtual terminal
Default:
N/A
Usage Guide:
To enter line mode
Example:
To enter line mode (vty 1)
Switch# configure terminal
Switch (config)# line vty 1
Switch (config-line)#
do
Command:
do < exec commands >
do To run exec commands.
NS4702-24P-4X Managed Switch Command Guide
System priority
Chapter 4: Commands for CLI configuration
147