Electrical Connections - Teledyne 300E Instruction Manual

Model 300E Carbon Monoxide Analyzer
Instruction Manual
8. VENTILATION CLEARANCE: Whether the analyzer is set up on a bench or
installed into an instrument rack, be sure to leave sufficient ventilation
clearance.
Above and below the instrument
Various rack mount kits are available for this analyzer. See Section 5.1 of
q
this manual for more information.

3.1.1. Electrical Connections

1. Refer to Figure 3-2 for the location of the rear panel electrical connections.
2. Attach a strip chart recorder and/or data-logger to the appropriate analog
output connections on the rear panel of the analyzer.
The A1 and A2 channels output a signal that is proportional to the CO
concentration of the Sample Gas. Either can be used for connecting the analog
output signal to a chart recorder or for interfacing with a datalogger.
P/N 04288 REV: A
AREA
Back of the instrument
Sides of the instrument
Check the voltage and frequency label on the rear panel of the
instrument (See Figure 3-2) for compatibility with the local power
before plugging the M300E into line power.
Power connection MUST have functioning ground connection.
A1
1 2
MINIMUM REQUIRED
CLEARANCE
CAUTION
CAUTION
ANALOG
A2 A3 A4
3 4 5 6 7 8
Getting Started
4 in.
1 in.
1 in.
23