Calibration Procedures; Before Calibration - Teledyne 300E Instruction Manual

Model 300E Carbon Monoxide Analyzer
Instruction Manual

7. CALIBRATION PROCEDURES

This section contains a variety of information regarding the various methods for
calibrating a Model 300E Co Analyzer as well as other supporting information. For
information on EPA Protocol Calibration please refer to Section 8. This section is
organized as follows:
SECTION 7.1 – BEFORE CALIBRATION
This section contains general information you should know before about calibrating
the analyzer.
SECTION 7.2 - MANUAL ZERO/SPAN CALIBRATION
This section describes the procedure for checking or calibrating the instrument with
no Zero/Span Valves installed or if installed, not operating. It requires that Zero
Air and Span Gas be inlet through the SAMPLE port.
SECTION 7.3 - MANUAL ZERO/SPAN CALIBRATION WITH ZERO/SPAN VALVES
This section describes the procedure for checking or calibrating the instrument with
Zero/Span Valves installed and operating but controlled manually through the
keypad on the Front Panel of the instrument. This section also includes a section
on activating the Zero/Span Valves via the Control In contact closures of the
analyzers External Digital I/O.
SECTION 7.4 - AUTOMATIC ZERO/SPAN CHECK WITH ZERO/SPAN VALVES
This section describes the procedure for using the AutoCal feature of the analyzer
to check or calibrate the instrument. The AutoCal feature requires that one of the
Zero/Span Valves Options be installed and operating.

7.1. Before Calibration

The calibration procedures in this section assume that the Range Type, Range Span
and units of measure have already been selected for the analyzer. If this has not
been done, please do so before continuing (see Section 6.4 for instructions).
All Gas lines should be PTFE (Teflon), FEP, glass, stainless steel or brass
If any problems occur while performing the following calibration procedures, refer to Section 11
of this manual for troubleshooting tips.
P/N 04288 REV: A
OPTION INSTALLED.
OPTIONS INSTALLED
NOTE
CALIBRATION PROCEDURES
123