Teledyne 300E Instruction Manual page 26

Getting Started
A
Z
E
R A
O N
Input #
A
B
C
D
E
F
U
+
5. If you wish to utilize either of the analyzer's two serial interfaces, refer to
Section 6.8 of this manual for instructions on their configuration and usage.
26
CONTROL IN
B C D E F
S
P
Local Power Connections
Status
Definition
REMOTE ZERO The Analyzer is placed in Zero Calibration mode. The mode
CAL field of the display will read ZERO CAL R.
REMOTE The Analyzer is placed in Span Calibration mode. The mode
SPAN CAL field of the display will read SPAN CAL R.
SPARE
SPARE
SPARE
SPARE
Digital Ground May be connected to the ground of the datalogger/recorder.
Input pin for +5 VDC required to activate pins A – F. This
Pullup supply
can be from an external source or from the "+" pin of the
for inputs
instruments STATUS connector.
Internal +5V Internal source of +5V which can be used to actuate control
Supply inputs when jumpered to the U pin.
Model 300E Carbon Monoxide Analyzer
A B
U +
Z S
E P
R A
O N
-
External Power Connections
On Condition
Instruction Manual
CONTROL IN
C D E F U +
+
5 VDC Power
Supply
P/N 04288 REV: A