Operating Instructions; Operating Modes; Figure 6-1: Front Panel Display - Teledyne 300E Instruction Manual

Model 300E Carbon Monoxide Analyzer
Instruction Manual

6. OPERATING INSTRUCTIONS

To assist in navigating the analyzer's software, a series of Menu Trees can be found
in Appendix A of this manual.

6.1. Operating Modes

The M300E software has a variety of operating modes. Most commonly, the
analyzer will be operating in SAMPLE mode. In this mode, a continuous read-out of
the CO concentration is displayed on the front panel and output as an analog
voltage from rear panel terminals, calibrations can be performed, and TEST and
WARNING functions can be examined.
The second most important operating mode is SETUP mode. This mode is used for
performing certain configuration operations, such as for the iDAS system, the
Analog Output ranges, or the serial (RS-232/RS-485/Ethernet) communication
channels. The Set up mode is also used for performing various diagnostic tests
during troubleshooting.
ADVANCED POLLUTION INSTRUMENTATION, INC.
The Mode Field of the Front Panel Display indicates to the user which operating
mode the unit is currently running. Besides SAMPLE and SETUP, other modes the
analyzer can be operated in are:
The following flowcharts contain typical representations of the analyzer's display during the
various operations being described.
These representations are not intended to be exact and may differ slightly from the actual
display of your instrument.
P/N 04288 REV: A
KEY DEFINITIONS
MODE FIELD
SAMPLE A
<TST TST>
GAS FILTER CORRELATION ANALYZER - MODEL 300E
Figure 6–1: Front Panel Display
MESSAGE FIELD
CO = 40.0
RANGE = 50 PPM
CAL CALZ CALS
NOTE
Operating Instructions
CONCENTRATION FIELD
SAMPLE
CAL
SETUP
FAULT
POWER
51