Model 300E Carbon Monoxide Analyzer
Instruction Manual
29. Remove the TWO (2) screws holding protective metal cover over Wheel
Temperature Sensor and the GFC Wheel Heater.
30. Carefully remove the cover and the stand-offs located between the cover ands
the GFC Wheel Housing.
THERMISTOR
31. Remove the TWO (2) screws holding protective metal cover over the
Opto-Pickup printed circuit assembly to the GFC Wheel housing.
32. Carefully remove the cover from the Opto-Pickup printed circuit assembly.
P/N 04288 REV: A
HEATER
Figure 11-7: Removing the GFC Sensor Heater Cover
TROUBLESHOOTING & REPAIR PROCEDURES
SOURCE ASSEMBLY
SYNCHRONOUS MOTOR
SAFETY SHIELD
219