Table 1.1 Snmp Setting Items - Fujitsu ETERNUS LT20 S2 User Manual

(1)
(2)
(3)
(4)
(5)
(6)
7) After entering data for all items, click the "Submit" button.
P3AM-5262-01ENZ0

Table 1.1 SNMP setting items

Item
Community Set the community name of SNMP.
Name - Initial value: public (for this device, the setting is
SNMP Enable Set Enabled or Disabled for the SNMP function.
- If you check this, you can manage this device from
- Initial value: not checked.
IPv4 SNMP - Up to three Target Addresses can be set.
Target Address
- Set the IP address of the SNMP Trap destination in
(SNMP Trap
notification
- Initial value: 0.0.0.0 (entry is disabled.)
destination)
IPv6 SNMP not supported (cannot be used)
Target Address
- Up to three Target Addresses can be set.
(SNMP Trap
- Set the IP address of the SNMP Trap destination in
notification
destination)
- Initial value: 0:0:0:0:0:0:0:0 (entry is disabled.)
Version Set the Version of SNMP.
- This can be set for each Target Address.
- If "ETERNUS SF Storage Cruiser" is used, select
SNMP Trap Set the event type for which the SNMP Trap
Notification Filter notification is sent.
(SNMP You can choose to use one of the four types: "Critical
notification level Events," "Critical and Warning Events," "Critical,
setting) Warning and Configuration Events," and "Critical,
Warning, Configuration and Information Events."
* The initial value is "Critical, Warning, Configuration
initial value only.)
other computers running the SNMP management
software.
According to the "Protocol Version" selected in the
"Network" tab in the "Configuration" window, either
or both of the "IPv4 SNMP Target Address" field and
"IPv6 SNMP Target Address" field are enabled for
entry.
the XXX.XXX.XXX.XXX format (in decimal).
the xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx format
(in hexadecimal).
"v1."
and Information Events."
1.3 SNMP Setting Procedure
Setting
1-5