Configuration Of An Interface Measurement - Endress+Hauser Levelflex FMP51 Operating Instructions Manual

Levelflex FMP51, FMP52, FMP54
Endress+Hauser
Step Parameter
Setup ® Signal quality
10
Setup ® Mapping ® Confirm
11
4)
distance
1) only visible for devices with "interface measurement" application package
2) only visible for coated probes and if "Tank type" = "Bypass/pipe"
3) If required, lower DCs can be entered into "Setup ® Advanced Setup ® Level ® Medium property". However,
for DC<1.6 the measuring range may be reduced. For details please contact Endress+Hauser.
4) For FMP54 with gas phase compensation (product structure: feature 540 "Application Package", option EF or EG) a
map must NOT be recorded.
10.7

Configuration of an interface measurement

Only devices with the respective software option can be used for interface measurements.
This option is selected in the product structure: Feature 540 "Application package", option
EB "Interface measurement".
R
D
L
D
I
UP
LN
L
L
L
I
Configuration parameters for interface measurements
å 29
R = Reference pioint of the measurement
E = Empty calibration (= zero point)
F = Full calibration (= span)
LN = Length of probe
UP = Thickness of upper medium
Schritt Parameter
Setup ® Distance unit
1
2 Setup ® Operating mode
Setup ® Tank type
3
Setup ® Tube diameter
4
Commissioning via operating menu (On-site display, FieldCare)
Action
Displays the signal quality of the level
echo.
Compare the displayed distance to the
real distance in order to start the
recording of the mapping curve.
DK ( DC )
1 1
DK (DC )
2 2
D = Distance of interface (Distance from reference point to lower medium)
I
L = Interface level
I
D = Distance from reference point R to total level
L
L = total level
L
Aktion
Select distance unit.
1)
Select "Interface".
Select tank type.
2)
Enter the diameter of the bypass or stilling well.
Description
(® ä 122)
(® ä 124)
100%
E
F
0%
Beschreibung
(® ä 116)
(® ä 116)
(® ä 117)
(® ä 117)
A0011177
81