Endress+Hauser Levelflex FMP51 Operating Instructions Manual page 167

Levelflex FMP51, FMP52, FMP54
Description
Selection
Factory setting
Decimal places menu
Navigation
Description
Selection
Factory setting
Additional information
Endress+Hauser
Selection of the number format for the representation of measured values.
• Decimal
• ft-in-1/16" (Only valid for distance units)
Decimal
Setup ® Advanced setup ® Display ® Dec. places menu
Number of decimal places for the representation of numbers within the operating menu.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xxxx
This parameter only determines the representation of numbers within the operating menu (e.g.
Empty calibration, Full calibration). It does not affect the measured value representation.
For measured values, the number of decimal places is defined in the Decimal places 1 to
Decimal places 4 parameters (® ä 161).
Description of device parameters (operating menu)
167