Endress+Hauser Levelflex FMP51 Operating Instructions Manual page 141

Levelflex FMP51, FMP52, FMP54
Additional information
Customer value
Navigation
Condition
Description
Input range
Factory setting
Activate table
Navigation
Condition
Description
Selection
Factory setting
Additional information
Endress+Hauser
For Table mode = Manual: Level is a writable parameter.
For Table mode = Semi-automatic: Level is a read-only parameter.
Setup ® Advanced setup ® Linearization ® Customer value
Only visible if the "Table" linearization type has been selected.
Specification of the linearized value of the respective linearization point.
-3,0 x 10 38 ... +3,0 x 10 38
0
Setup ® Advanced setup ® Linearization ® Activate table
Only visible if the "Table" linearization type has been selected.
Enables or disables the linearization table.
• Disable
A linearization is not calculated. If the Linearization type parameter has been set to Table,
the error message F435 is generated.
• Enable
The measured value is linearized according to the table before being sent to the output.
Disable
When editing the table, this parameter is automatically reset to the Disable option. After finishing
the editing procedure it must be set to the Enable option again.
Description of device parameters (operating menu)
141