Read Calibration Data - Agilent Technologies 4396B Gpib Programming Manual

c b
Figure 5-1. Sample Program : To Modify Calibration Data (2/2)
This program measures calibration standards, reads the obtained calibration data, and restores
the data in the analyzer. For details on how to obtain the calibration data by measuring the
standard, see Chapter 1. For details on how to transfer the data arrays, see Chapter 4.

Read Calibration Data

The controller can read out the error coecients using the GPIB commands .
Each point is a real/imaginary pair, and the number of points in the array is the same as the
number of points in the sweep. For details on data transfer, see Chapter 4.
Each calibration type uses only as many arrays as needed, starting with array 1, and each array
stores a speci c error coecient. Therefore, it is necessary to know the type of calibration
about to be read out: attempting to read an array not being used in the current calibration
causes the \REQUESTED DATA NOT CURRENTLY AVAILABLE" warning to be displayed. For
assignment of data arrays, see the manual.
GPIB Command Reference
5-2 Writing Data Arrays to the Analyzer