Using Instrument Basic With An External Controller - Agilent Technologies 4396B Gpib Programming Manual

Using Instrument BASIC with an External Controller

This program transfers a program from the Instrument BASIC memory to the external
controller's disk through the GPIB interface. This program must be executed on the external
controller.
For other topics listed below, see Chapter 7, \Controlling Instrument BASIC
Note
from Remote," of the
d
c
Transferring the Program to an External Controller (on the External Controller)
Lines 50 to 90 read the le header:
The rst byte is always \#".
speci es the number of bytes that de nes the program size.
. . . is program size in byte ( digits).
See
information.
The program to be uploaded must be in either the paused or stopped state.
Note
6-4 Application Programs
GPIB Programming Guide.
Passing control between controllers
Transferring a program to Instrument BASIC
Running Instrument BASIC program from an external controller program
Referring to an external controller's data array contents
in Chapter 2 of the
Figure 6-6.
. . . .
GPIB Command Reference
a
b
for more