Editing Programs; Getting Into/Out Of The Edit Mode; Getting Into The Edit Mode Using The Front Panel Keys; Entering The Edit Mode From The Keyboard - Agilent Technologies 4396B Gpib Programming Manual

Editing Programs

This chapter describes how to edit programs using the EDIT mode. The topics covered in this
chapter are:

Getting into/out of the EDIT mode

Editing programs in the EDIT mode
Renumbering program line numbers
Getting Into/Out of the EDIT Mode

Getting Into the EDIT Mode using the Front Panel Keys

Pressing the following key and softkey allows you to enter the EDIT mode immediately,
irrespective of Display Allocation.
NNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNN
4 System 5

Entering the EDIT Mode from the Keyboard

Use the following keys to enter the EDIT mode with the cursor positioned at the speci ed line
number. The
line number
leads to the -
4 Shift 5 4 F9
NNNNNNNNNNNNNN
line number
or type as follows:
line number
To use the keyboard, the Keyboard Input Line must be allocated on the screen. If it is not,
press
NNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Display
4 5

Getting Out of the EDIT Mode

The EDIT mode is exited by pressing
by pressing the
NNNNNNNNNNNNNNNNNNNNNNNNNN
can be omitted. Press the following key among the 3 menus which
key.
5
Enter
4 5
4 Enter 5
4 Shift 5
softkey).
and select any allocation except ALL INSTRUMENT.
- - , , and
4 Alt 5 4 F4 5 4 ESC 5
from the keyboard (or
4 Home 5
Editing Programs 5-1
5