Agilent Technologies 4396B Gpib Programming Manual page 119

The commands are automatically entered at the current cursor position like this:
d
5. Press the following key:
2
1
4 5
The system reads the entire line.
d
6. Press the following softkey:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
The following characters are displayed on the screen:
d
7. Press the following key and softkey to preset the analyzer:
4 Preset 5
The GPIB command to preset the analyzer \
cursor position like this:
d
2
Then press .
4 1 5
\;" preceding the GPIB command is automatically added, when you write the
Note
program by pressing keys. \;" is a separator to send more than one command in
the same message.
8. Press the following key to select measurement parameter as A/R:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
The program code is automatically generated:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNN NNNNNNNNNNN
Meas
4 5
" is automatically entered at the current
Writing and Running Programs 3-3
a
a
a
a