Set The Receive Array; Sample Program : To Get Measurement Trace Using Ieee 64-Bit Floating Point - Agilent Technologies 4396B Gpib Programming Manual

Before running the program in Figure 4-5, you must modify the dimension of the data arrays to
match the analyzer type (network or spectrum). (See the \Set the Receive Array" below.)
d
c
Sample Program : To Get Measurement Trace Using IEEE 64-bit Floating Point Format

Set the Receive Array

Line 190 sets the array size to the maximum number of data. The analyzer's maximum number
of measurement points is 801. At end of data, the terminator \
In this example, it is assumed that the analyzer is in the network analyzer mode of operation,
in which each point has complex data. If you use the analyzer in the spectrum analyzer mode,
each measurement point has only real data, so you must set the data array
Figure 4-5.
(For Instrument BASIC)
^ " is sent (see Figure 4-4).
lf eoi
as follows:
Reading Measurement Data
a
b
4-9