If The Disk Cannot Be Read - Agilent Technologies 4396B Gpib Programming Manual

If the Disk Cannot Be Read

Check the disk.
1. Put the disk into the disk drive and type as follows.
d
2. Press .
4 Return 5
If error message is displayed, the disk is corrupted or the disk format does not match. Use
another disk.
If you are using the external controller,
BASIC uses the LIF format, but doesn't use DOS format. Instrument
BASIC uses both the LIF and the DOS format. Try again on using
Instrument BASIC.
Check the mass storage.
1. Put the disk into the disk drive and type as follows:
d
2. Press .
4 Return 5
d
3. If the mass storage volume does not match your disk drive, use the
to match.
If you are using Instrument BASIC:
To use the built-in disk drive, mass storage volume speci er must be
12-2 If Y ou Have a Problem
mass storage volume speci er
a
a
a
statement to set it
.