Writing Data Arrays To The Analyzer; To Modify Calibration Data; Sample Program : To Modify Calibration Data - Agilent Technologies 4396B Gpib Programming Manual

Writing Data Arrays to the Analyzer

Chapter 4 explained how to read data arrays from the analyzer. This chapter shows how
to write data arrays to the analyzer. You can read, modify, and store the data arrays to the
analyzer over the GPIB. This allows you to modify the trace on the analyzer's display. For
details on the data arrays in the analyzer, see the

To Modify Calibration Data

Note
If you change measurement conditions (for example, START frequency, STOP
frequency, NOP, and IFBW) of this instrument after exporting a calibration
coecient array using the OUTPCALC
using the INPUCALC
coecient array are destroyed and become invalid. If you want to perform in
this way, use the SAVDSTA command to save data as STATE and recall it using
the RECD command.
d
Figure 5-1. Sample Program : To Modify Calibration Data (1/2)
GPIB Command Reference
f
1-12
f g
1-12 command, contents of the imported calibration
manual.
g
? command and inporting it again
Writing Data Arrays to the Analyzer
5
a
5-1