To Program a Basic Measurement
This section describes how to organize the commands into a measurement sequence. Figure 1-2
shows a typical program
ow for a measurement.
The following program performs the measurement
ow controlling the analyzer using GPIB.
This guide shows program lists of sample programs for an external controller. To
use the sample programs in this guide with Instrument BASIC, change the select
code from 7 to 8 and change the GPIB address from 17 to 00 (that is, use 800
instead of 717).
d
Figure 1-2. Program Flow
Figure 1-3. Sample Program : Basic Measurement (1/2)
Learning GPIB Remote Control Basics
a
1-5