Report Command Error; Output Error - Agilent Technologies 4396B Gpib Programming Manual

Figure 3-6. Command-Error Bit Enabling

Report Command Error

If an GPIB command (executed between lines 100 and 160) causes an GPIB command error,
the analyzer generates an SRQ and the controller branches to . For example, the
statement:
Setting center frequency, but no parameter
causes an SRQ interrupt and branch to .

Output Error

These commands retrieve the error number and description.
In the error shown in the line 120 example, the controller displays the following:
3-6 Synchronizing the Analyzer from Remote