Return To Execute Gpib Command - Agilent Technologies 4396B Gpib Programming Manual

d a

Return to Execute GPIB command

Lines 230 to 270 clear SRQ before returning to the main routine.
Line 230 reads the analyzer's status byte. The statement reads the Status
Byte Register of the address (analyzer), and enters the value into . The command
error causes the SRQ and with bit 5 and bit 6 of the Status Byte Register set, the value of is
96. Reading the Status Byte Register by using the command clears SRQ (status byte bit
6).
In line 240 and line 250, the command reads the contents of the Standard Event Status
Register. With Bit 5 of Standard Event Status Register set, the value of is 32. Reading
the Standard Event Status Register by using the command clears the register.
A branch to disables the interrupt. Therefore, the return from must
reenable the interrupt.
Synchronizing the Analyzer from Remote 3-7