Saving And Getting Programs; Saving Programs (Save) - Agilent Technologies 4396B Gpib Programming Manual

Saving and Getting Programs

This chapter describes how to save and get programs to or from the built-in exible disk drive
and RAM disk memory. Topics of this chapter are:

Saving programs (SAVE)

Listing le names (CAT)
Getting programs (GET)
If you are using the disk drive for the rst time, see \To Save and Recall" in Chapter 6 of the
Task Reference.
Instrument BASIC on the analyzer cannot communicate with an external disk
Note
drive.
The analyzer can use either LIF (Logical Interchange Format) or DOS (Disk
Note
Operating System) formatted disks. The instrument automatically detects the
disk format. It can use most of the same operations for either disk format.
Saving Programs (SAVE)
1. To use the built-in disk drive, insert a 2DD disk or 2HD disk into the disk drive.
2. If you are using a exible disk for the rst time, set the disk format to LIF or DOS and
initialize the disk. See \To Save and Recall" in Chapter 6 of the
procedure.
When the analyzer is turned on, the RAM disk memory is automatically
Note
initialized by the format that is set by
under
and Recall" in Chapter 6 of the
3. If the display allocation is ALL INSTRUMENT, change the allocation. For example:
NNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Display
4 5
4. Specify the system mass storage device as follows:
When you want to use the built-in disk drive, type in
then press
Enter
4
When you want to use the RAM disk memory, type in
then press
4 Enter
5. Press the following key among the 3 menus which leads to the
the lename to which you will store the program as follows:
. If you want to change the disk format, initialize it. See \To Save
4 Save 5
.
5
.
5
Task Reference
under
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
for the procedure.
Task Reference
4 Shift
for the
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
or
or
- key. And type in
5 4 F9 5
Saving and Getting Programs 4-1
4
,
,