To Get Measurement Trace Using Binary Format
Two programs are shown to get the data arrays using binary format in Figure 4-3 and
Figure 4-5.
Figure 4-3
For the external controller
Using
command (line 220) to allow
for the change in the number of
measurement points.
Before running the program in Figure 4-3, you must modify the dimension of the data arrays to
match to the analyzer type (network or spectrum). (See the \Set the Receive Array" example.)
d
Sample Program : To Get Measurement Trace Using IEEE 64-bit Floating Point Format
4-6
Reading Measurement Data
Instrument BASIC allows for a dierent
number of data points then the number
specied in the data array declaration.
Figure 4-3.
(For External Controller) (1/2)
Figure 4-5
For the Instrument BASIC
a