Listing File Names (Cat); Listing To Screen - Agilent Technologies 4396B Gpib Programming Manual

NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNN
You can also save the le from the keyboard. Type and press as follows:
le name
The program is stored on the disk.
If you get the error 257, \
Note
name you are trying to use. In this case, you have three choices:
Pick a new le name that doesn't already exist. To determine which le
names are already being used, use the \
Replace an existing le, use the \
Purge the old le using the

Listing File Names (CAT)

Listing to Screen

Press the following key and softkeys:
1. If the display allocation is ALL INSTRUMENT or BASIC STATUS, change the allocation to
either HALF INSTRument HALF BASIC or ALL BASIC. For example:
NNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Display
4 5
2. Press the following key among the 3 menus which leads to the
(on the keyboard)
4 Menu 5
You can list from the keyboard as follows:
Type in then press
The le names stored on the disk are listed on the screen.
Because the CAT statement outputs 80 columns to a line and the maximum
Note
number of columns to a screen is 61, each line is wrapped at the 62th column.
If you do not want the list to wrap around, execute the following statement
before executing the CAT command.
CAT will list the le names with no wrap around, but anything after the 62th
column in the output cannot be seen.
4-2 Saving and Getting Programs
le name
4 Enter
Enter
4 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNN
.
Enter
4 5
5
", a le on the disk already has the
" command (see below).
" statement.
command, then save the new one.
4 Enter 5
- key:
4 Shift 5 4 F9 5