Table of Contents
Advertisement
WEB Browser System Configuration
The DMS-3K is configured through the web browser. The configuration consists of setting up
the alarm inputs and outputs, setting the time and date and the device communications. All
configuration items require a log-in of administrator. A user log-in will let you view the
configuration, but not make any changes.
Whenever making a change to the configuration, you must press the apply button.
The DMS-3K comes from the factory pre-configured for the number of inputs and outputs as
specified in the DMS Model Number. Reference the System Configuration Sheet for the exact
number of inputs, outputs and their location in the card rack. Each I/O module has factory
configured switch settings to determine their addressing. For example, a system with (3) 16I
Input modules will be configured for inputs 1-16, 17-32 and 33-48.
The configuration process consists of the following steps. It is not required to configure every
single item in the system. The items highlighted in bold should be configured as a minimum.
Other items (non bold) are used depending on the options installed in the system or personal
preferences.
1. Alarm Inputs
Use this to enable or disable an alarm, set up alarm filters, program NO/NC (normally
open/normally closed) contact states, set up control groups and configure alarm/normal
legends
2. Control Inputs
Use this to assign the various control functions (Acknowledge, test, silence, test, etc) to
the input channels. Set up operational alarm sequences for lamp outputs.
54
Advertisement
Table of Contents
