Table of Contents
Advertisement
Figure 3–16b Ethernet Communications Configuration Page (Bottom Half)
DNP Protocol (option)
The DMS-3K DNP port will transmit the status and timestamp of each alarm. The transmitted alarms
can be used to drive an RTU, SCADA, PLC or other device. Refer to Appendix B for detailed DNP
operation and mapping.
The DNP implementation over Ethernet requires the assignment of a TCP Port for the DMS-3K DNP
Slave, a DNP Device Address (1-65,535), Destination IP Address for the remote DNP Master and
Data Link Confirm (Always, Sometime or Never)
Page 81 of 206
Advertisement
Table of Contents
