Table of Contents
Advertisement
Ethernet Communications Configuration (optional)
On this page, you configure the unit's Ethernet Communications parameters. The Ethernet port
supports 10Mbs or 100Mbs using simultaneous Modbus TCP/IP and DNP communication protocols.
The Modbus TCP/IP set-up is similar to the serial Modbus, except for the following:
• Master Mode:
The Modbus TCP/IP Master will support up to 12 Modbus TCP/IP Slave Devices.
The Modbus TCP Port (default is 502) is for the DMS-3K Master.
You enter the IP addresses for each of the slave ports you configure.
• Slave Mode:
The DMS-3K Modbus TCP/IP Slave can connect to multiple Modbus TCP/IP Master Devices.
After making your changes, click Apply.
Figure 3–16a Ethernet Communications Configuration Page (Top Half)
80
Advertisement
Table of Contents
