Table of Contents
Advertisement
Network Configuration
This page allows the administrator to configure the network settings. Refer to the following figure.
Here you can change your IP address. All units in the network must have a unique IP address. The
network administrator configures the network & gateway information according to your location.
If you enable DHCP, you must enter the DNS servers (Nameserver) and the domain into the
appropriate fields.
Notice the Ping test field and button at the bottom. If you suspect a unit is not responding or question
its connectivity, type its IP address into this field and click the Test button. The DMS-3K will ping the
requested unit. The results will be displayed in a new Web browser window.
After all settings have been made, click the Apply button for those changes to take effect. If you wish
to clear all fields to start over, click the Discard button. The "Reboot DMS-3K" button is available if
you wish to restart the system. If using NTP, you must have the Gateway configured properly for NTP
to synchronize to its server.
Figure 3–23 Network Configuration Page
86
Advertisement
Table of Contents
