Nak Character - Datalogic Magellan 1500i Product Reference Manual

RS-232 ACK NAK Features
RS-232 NAK Character
This feature specifies which ASCII character will be used as a NAK character.
To specify the RS-232 NAK Character:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode, SET RS-232 NAK Character below. You'll need to cover
3. Scan the appropriate digits from the
4. The scanner will automatically exit Programming Mode when the appro-
DEFAULT
Product Reference Guide
DO NOT set this feature to use previously defined char-
acters such as XON, XOFF or host commands as this will
conflict with normal operation of these characters. 8-bit
data is not recognized when the feature, RS-232 Num-
NOTE
ber of Data Bits, is set to 7 data bits.
any unused barcodes on this and the facing page to ensure the scanner
reads only the barcode you intend to scan.
that represent the hex designation for the desired character. A table con-
taining the ASCII Character Set and their corresponding Hex Values is
available in the inside back cover of this manual. ASCII parameters must be
input by scanning a pair of hexadecimal digits for the desired character.
For example, if ASCII "A" were the desired NAK character, you would scan
the digits "4", then "1" (the ASCII corresponding hex value).
priate amount of digits/characters have been scanned.
Enter/Exit Programming Mode
Alpha-Numeric Keypad in Appendix C
0320(CR)
Set RS-232 NAK Character
Default setting for this feature is:
15
91