Input Port Properties; Hdmi Inputs - Lightware MX2-8x8-DH-4DPio-A User Manual

   
7. Software Control – Lightware Device Controller
7.5. Input Port Properties
7.5.1. HDMI Inputs
Click on a port to display its properties; Signal status information and the most important parameters are
displayed.
General Tab - General
General tab in the input port properties window
Port name
The name of a port can be changed by typing the new name and clicking on the Set button. The following
characters are allowed when naming: Letters (A-Z) and (a-z), hyphen (-), underscore (_), numbers (0-9), and
dot (.). Max length: 63 characters.
Mute #mute #unmute
The incoming signal can be muted/unmuted by pressing the button. If the port is muted, button text is
Unmute. In this case, no signal is transmitted from the input port.
Lock #lock #unlock
The port can be locked to the currently connected output ports by the button. If the port is locked, button text
is Unlock. In this case the mute state and the crosspoint cannot be changed.
Switch to all
The input port will be switched to all output ports.
Emulated EDID
The name of the currently emulated EDID (displays the Monitor Name in the EDID menu).
MX2 Standalone Matrix Switcher series – User's Manual
General Tab - Video Settings
HDCP Enable
▪
▪
▪
▪
*The availability of this setting depends on the hardware version of the input board (V1x_) and the port type
(HDMI), only in MX2-8x8-HDMI20 model. The hardware version can be found in the
in the
Resetting the default values: HDCP = HDCP 2.2 and HDCP 1.4.
General Tab - Audio Settings
Audio source
▪
▪
▪

DIFFERENCE:
audio port beside the video port.
Mute analog input
The analog audio input signal can be muted by this option.
Analog input gain
Setting the value between -12 dB and +35 dB.
Analog input volume
Setting the value between -95.62 dB and 0 dB.
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
#hdcp
Disable HDCP on input: The connected source will detect that the matrix is not HDCP-compliant and turn
off authentication if the content allows it.
Allow HDCP 1.4 only *: The connected source will detect that the matrix is compliant with HDCP 1.4, but not
compliant with HDCP 2.2.
Allow HDCP 2.2 and HDCP 1.4: The connected source will detect that the matrix is compliant with HDCP
2.2.
High Value mode (limit switching to HDCP 2.2 sinks): Any version of HDCP is allowed on the input, but the
incoming signal is always internally upconverted to HDCP 2.2 content and thus cannot be switched
to HDCP 1.4 sinks.
System Settings Menu, Device Info submenu in the LCD.
Analog audio settings in the output port properties window
#audio #analogaudio
Off: audio is not embedded in the video stream.
HDMI: the audio of the incoming video stream is embedded in the video.
Analog input : the analog audio input signal is embedded in the video.
Analog audio properties appear only in -Audio or -A suffixed models, where there is an analog
47
Status Tab in the LDC or