Tracker Off-Road 800SX Service Manual page 34

MOD306
5. Remove the snap ring on the steering column; then
remove the washer (A) and thrust washer (B); then
slide the shift lever off of the steering housing.
MOD307
MOD308
INSTALLING
1. Lightly grease the inner portion of the shift lever;
then slide the shift lever onto the steering housing;
then install the thrust washer (B) and washer (A);
then install the snap ring.
32
MOD308
MOD307
2. Install the adjuster bracket to the bottom of the steer-
ing housing; then install two the cap screws. Tighten
to 24 in-lb (2.72 N-m).
MOD306
3. Position the shift cable to the shift lever using the
existing cap screw and a new lock nut. Tighten to
6 ft-lb (8.2 N-m).
4. Position the steering adjuster into place; then install
the lower and upper steering adjuster cap screws.
Tighten both to 6 ft-lb (8.2 N-m). Install the steering
wheel. Tighten to 25 ft-lb (34 N-m).
5. Install the lock clip on the steering shaft; then install
the steering wheel cover.
NOTE: If the hole in the steering shaft does not

align with the slots in the castle nut, tighten the nut
slightly until the next slot aligns with the hole.